The HSP100ID Indirect Fired Heaters are highly efficient devices that provide large volume of 100% clean, dry and fume free warm air. They are best for places with limited ventilation like shops, event tents, food preparation areas, exhibition halls, and construction sites. They can be used with flexible duct that spreads the warm air around easily.
HeatStar PRO-SERIES 122,000 BTU/HR Indirect Fired Heater. The HSP100ID is an ideal heating soloution when paired with 25' of 14" duct and a remote thermostat. This indirect fired heater is an ideal solution for delivering even heat to both event tents and construction sites with clean fresh heated air. You can place the heater outside the space and duct the warm air in or for a fuel savings you can place the heater in the space to be heated and vent the exhaust out. Either way it is hard to beat the comfort and safety of indirect heat.
Heat exchanger to keep exhaust gas and heated air separate
17 gallon tank capacity
Powerful fans ensure high static pressure
Long life stainless steel combustion chamber
Electronic flame control
Water resistant flame control box
Automatic safety and control devices
Optional thermostat available for constant temperature control
RAIN POLICY: You can reschedule your rental due to rain at no extra cost as long as 24 hour notice is given.
OCCUPANCY: A maximum of 5-6 kids of equal size at one time for bounce houses, and 1 person at a time for slides is what most inflatable manufacturers recommend.
CLEANING: All units are cleaned and sanitized before use.
WHAT'S INCLUDED:
Extension Cord
Blower
Safety Stakes to secure to ground
WHAT YOU'LL NEED:
Enough space for us to setup your rental
Electric outlet within 50 feet of setup area
Water source and water hose if renting a water slide
If you are taking measurements for a structure such as a building or fence, please provide the height of the structure here. If height does not apply to the wash, for instance for a gutter wash, leave this field empty. Please note if you enter a value here after taking measurements, you will need to take measurements again.
